Home > ALL PRODUCTS >

Performance Recoil Spring for all Saiga/Vepr Shotguns

Carolina saiga reduced power recoil springs guide rod Performance


 
Price: $5.95

Stock Status:
IN STOCK AVAILABLE FOR PURCHASE

SKU#: CSS-SPRING-1
Qty:

Description
 
Replaces your front recoil spring to make your shotguns more reliable.
Works on all Saiga and Vepr Shotguns.
Made in the USA.
Compression Weight 2.35# per inch. Fully Compressed (about 5") = 11lbs

This kit will help you run all 2 3/4" ammo from Slugs/Buck Shot to the low brass Walmart "100rd Value Pack" Remington and Federal birdshot.
Not for use with any 3" shells

This can be used with ALL 2-3/4" Shells.

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 19 Write a review »

  0 of 0 people found the following review helpful:
 
5 of 5 Registered 13.5 inch SBS working after installing November 8, 2022
Reviewer: Anonymous Person from Reno, NV United States  
I did a Form 1 SBS on my Vepr 12. Barrel was changed to 13.5 inches and never worked reliably after that. Years later I see this spring and gave it a try. With a shortened barrel I did not expect #7 or #8 target loads to work and they did not. The lowest power load that will work reliably is Federal #6 Game load and ejects the hull 2ft away. Fiocchi #4 Pheasant load ejects the hull 10ft away!


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Reliabilitah October 7, 2022
Reviewer: Anonymous Person  
My VP-12 went from not being able to reliably run 1145 loads on gas setting 3, to being able to run them on gas setting 2

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Low power spring in the front going into bolt September 14, 2022
Reviewer: Ceelo from Atlanta, GA United States  
Fixed my issues the factory spring is shorter and weaker. Full power spring in the rear and light spring in the  front going into the bolt carrier. I should have probably replaced the springs first before drilling gas ports and opening up the gas block hole but the gas block was covering 2 holes slightly. Either way she runs great now low and high brass mixed together in one mag not a single problem now. FYI get a auto plug 2.0 and Tapco gas puck and you are good to go.

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
5 of 5 vepr 12 parts July 6, 2022
Reviewer: gerrard kearns from Tacoma, WA United States  
Fast, efficient as always.....Thnxs Guys

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
5 of 5 Works great July 5, 2022
Reviewer: Marc in Michigan  
The performance recoil spring is a must have for shooting anything but high brass shells. It makes the Vepr purr with any kind of shells.

Was this review helpful to you?

View All Customer Reviews