Home > ALL PRODUCTS >

YUGO Serbian CHARGING HANDLE - CSS KNURLED BOLT ON - BLACK OXIDE Steel - fits M70 M85 M90 M92

CSS YUGO Serbian Charging Handle M70 M85 M90 M92


 
Alternative Views:


Price: $25.95

Stock Status:
IN STOCK AVAILABLE FOR PURCHASE

SKU#: CSS-CHARGING-HANDLE-YUGO-BLACK
Qty:

Description
 
RED THREAD LOCKER IS REQUIRED (Sold Seperately)

Bolts on to the existing charging handle to give you an enhanced (and smooth) oversized knob to operate your weapon easily.

Made in the USA of high quality black oxide steel.

Measures slightly longer than the other charging handles at 1 1/8"

Installation Instructions
1. Run the set screw completely through the handle, until it drops out into the center bore. That will ensure that screw is not stopping on any foreign debris left over from sand blasting.
2. Clean and degrease both the threads in the handle and the set screw with contact cleaner and allow to dry completely.
3. Apply red #262 Loctite to BOTH the set screw and the threads in the charging handle.
4. With the bolt carrier installed in the receiver, slide the charging handle over the OEM handle and start the set screw. The set screw should be facing or pointing forward. Slowly turn the set screw inward as you wiggle the handle in order to allow the set screw to find the "sweet spot" in the saddle of the OEM handle.
5. Using a large 4.5" long allen wrench, hoss that screw down until you think it's about to break. It won't.

recommended accessories for this product
THREAD LOCKER
Price: $1.99
LOCTITE BLUE RED GREEN THREAD LOCKER

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 23 Write a review »

  0 of 0 people found the following review helpful:
 
3 of 5 Quality Made but.... March 23, 2023
Reviewer: Matthew Hewett from Charlotte, NC United States  
The product is very well made, the quality is incredibly high, but the installation instructions were somewhat vague. No specifications on how tightly you need to torque down the set screw. Tightened the screw and then racked the weapon a few times to check for function,  on the third time the handle flew off. I had to take my torque driver and set it to 50 inch pounds to get it to hold in place.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Yugo M70 Charging Handle Knob March 13, 2023
Reviewer: Daryn Sebelius from IA United States  
Perfect fit on my M70. Make sure you use Loctite on both threads and it won’t go anywhere

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Extended charging handle February 27, 2023
Reviewer: COLE  
Did as instructed, solid as a rock after installing. Be sure to use loctite

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
2 of 5 Yugo Serbian Chargomg January 24, 2023
Reviewer: Mike Orozco from Phoenix, AZ United States  
Extended charging handle arrived quickly and is of good quality.  However would not stay on my M92 charging handle no matter how much loctite or how much I tightened.  Seems really well made but for me a no go so I’m the trash it went

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 December 27, 2022
Reviewer: James Piloto from Port Saint Lucie, FL United States  


Was this review helpful to you?

View All Customer Reviews