This precision turned pilot is made of heat treated 4140 (chrome moly) and finished in black oxide. It is designed to guide your Annular cutter into the right location to keep the barrel diameter concentric with the rifled barrel hole.
The cutter should be ran at slow RPMs (around 200), lubricated constantly, and a pilot used to keep it centered on the barrel properly.
ANNULAR Cutter(Shown in picture) is sold separately below. Carolina Shooters Supply Inc. expressly denies any liability for results that may occur from the proper, or improper, use of this tool. If you are unsure about using it, please do not order.
Reviews
Average Rating:
( 14 )
Bruce E. White from Whitewood, SD United States
June 1, 2026
Was this review helpful to you?
Josh Maggi from Lewiston, ID United States
February 8, 2026
Was this review helpful to you?
George MEYER from Odessa, FL United States
January 6, 2026
Was this review helpful to you?
Richard Stone from Louisville, KY United States
February 5, 2025
Cutters
Does cut , not as straight as a lathe but yes does cut
Was this review helpful to you?
Paul Miles from Alvarado, TX United States
March 13, 2024
Had an issue with the part bending. worked ok on the first use but deformed the second time around.
