 |
Solid Billet Aluminum part designed to fit the metal FIXED TUBULAR STOCK Vepr 12. It has a 3 degree angle to correct the angled receiver. Your Buttstock will be straight with the barrel and your cheek weld will setup for the factory fixed iron sights.
GUNSMITHING is required for installation. As with any AK47 part, some variation can occur from weapon to weapon. Please watch our VIDEO (LINK BELOW). In a few cases, customers have reported that the adapter will not slide in freely past the rivets inside the receiver (holding the rear trunnion in place). If this is the case, you will need to modify the adapter or remove a small amount or metal from the heads of the rivets.
Parts Needed for Fixed or Folding Skeleton stocks:
1. V12 Stock Adapter
2. Skeleton Stock: CSS-RAPTOR-STOCK, CSS-SKELETON-STOCK, ACE-STOCK, TRX-ALUMINUM-STK, TRX-ALUMINUM-LIMBSAVER-STK
3. Optional Folding Mechanisms: CSS-SFM-PUSHBUTTON or ACE-FOLDING-MECH
Parts Needed for Collapsible M4 AR15 Style Stocks:
1. V12 Stock Adapter
2. Pignose Adapter (CSS-PIGNOSE)
3. Mil-Spec or Commercial Buffer Tube (UTG-CARTUBE-MILSPEC or UTG-CARTUBE-COMMERCIAL)
4. Castle Nut (CSS-CAR-NUT)
5. Butt Stock or your choice (make sure you match to Mil-Spec or Commercial buffer tube)
Parts Needed for Folding Collapsible M4 AR15 Style Stocks:
Same as above plus add CSS-SFM-PUSHBUTTON or ACE-FOLDING-MECH
OR to use the ACE Pignose with folding mechanism, you need these parts:
1. V12 Stock Adapter
2. ACE Folding Pignose Adapter With Boss (ACE-FSM-AR)
3. Mil-Spec or Commercial Buffer Tube (UTG-CARTUBE-MILSPEC or UTG-CARTUBE-COMMERCIAL)
4. Castle Nut (CSS-CAR-NUT)
5. Butt Stock or your choice (make sure you match to Mil-Spec or Commercial buffer tube)
All needed hardware included.
Installation (SEE VIDEO) requires drilling / gunsmithing to remove the FIXED TUBULAR STOCK.
|
|
|
need some gunsmith work to fit it in 
It folds!!