Home > AK47, AK74 & AKM Parts >

Mag Catch Hardware - Screw Type Rivet

RAMS SUPERIOR Ak47 Saiga Vepr Rifle extended magazine release TACTICAL

Price: $7.95

Stock Status:


Mag Catch Hardware Kit for AK47, Saiga Rifle, VEPR Rifle.

Works with most AK47 Mag Catch products, including your factory Mag catch.

Spring sold separately.

1. Insert the Mag catch and catch spring into place and bend the spring into tension. Use the dowel pin to hold the spring in place as it is being compressed.
2. Line up the Mag catch so the holes are properly aligned with the holes in the tower and the catch spring is under full tension.
3. Insert the rivet through the catch tower and through the holes in the catch while pushing the dowel pin out the other side.
4. Once the rivet is completely installed, you can secure it in place. Install the lock washer and screw (thread locker recommended).

1 Threaded Rivet
1 Lock Washer
1 Dowel Pin

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 2 Write a review »

  0 of 0 people found the following review helpful:
5 of 5 Great Improvement Over Original September 3, 2021
Reviewer: Chris R from Trumbull, CT United States  
Excellent design, easy to install, and no need for peening.  I will be using one of these in every build from now on.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
5 of 5 Hardy replacement July 28, 2021
Reviewer: JD from SAINT AUGUSTINE, FL United States  
On my Mak 90 I needed a new rivet for my mag release catch. Hardest part was getting that dam spring and rivet inline with the other side. Once in just screw in the cap and done. Don't have to worry about drilling things out or flaring the ends. So much easier!! Thanks

Was this review helpful to you?