Home > ALL PRODUCTS >

THREADING TOOL - 7.62x39/308 PILOT for ANNULAR CUTTER

Saiga Vepr AK47 7.62x39 308 5/8 x 24 Inch Annular Pilot Cutter Kit #25547


 
Price: $13.99

Stock Status:
OUT OF STOCK


SKU#: CNCW-ANNULAR-PILOT-7.62
Qty:

Description
 
This precision turned pilot is made of heat treated 4140 (chrome moly) and finished in black oxide.
It is designed to guide your Annular cutter into the right location to keep the barrel diameter concentric with the rifled barrel hole.


The cutter should be ran at slow RPMs (around 200), lubricated constantly, and a pilot used to keep it centered on the barrel properly.

ANNULAR Cutter(Shown in picture) is sold separately below.

Carolina Shooters Supply Inc. expressly denies any liability for results that may occur from the proper, or improper, use of this tool. If you are unsure about using it, please do not order.



recommended accessories for this product
THREADING DIE STOCK HANDLE FOR 1 1/2" DIE THREAD CUTTING OIL THREADING DIE-14X1LH AK47, SAIGA 7.62, 5.45, 223
Price: $20.95
Price: $5.95
Price: $37.95
DIE STOCK HANDLE SAIGA BARREL THREADING AK47 AR15 VEPR SAIGA AK47 VEPR AR15 THREAD CUTTING OIL TAP MAGIC SAIGA AK47 7.62 THREADING DIES AND ALIGNMENT TOOL

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 32 Write a review »

  0 of 0 people found the following review helpful:
 
5 of 5 Good item March 14, 2024
Reviewer: Carlo Exmundo from SPRING, TX United States  
Item worked well exactly what I needed

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Threading tool. February 15, 2024
Reviewer: Michael Taylor from Clancy, MT United States  
Great product arrived in a short time. Works as advertised and does a great job. Will do more shopping at Carolina shooter supply.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 December 28, 2023
Reviewer: Dale Gribble from TX  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
1 of 5 Too small November 14, 2023
Reviewer: Ben Bogner from Wausau, WI United States  
Allowed a lot of play on my Remington 700 308 making the cut very uneven and inconsistent as it takes a lot of pressure and time to make the cut. Meeting the 0.0005" perpendicularity tolerance that Precision Arms calls for is just not possible with this pilot which risks a baffle strike. I would consider this product dangerously ineffective for a precision attachment.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 i used to aline 5/8 cutter September 27, 2023
Reviewer: Gregg williams from Gillett, PA United States  
i used this to aline the 5/8 cutter & it worked just fine!

Was this review helpful to you?

View All Customer Reviews