Return to ALG DEFENSE AKT-EL ENHANCED - MODIFIED FOR SAIGA and VEPR

Sort By:: Most Helpful Newest Rating: High to Low Rating: Low to High	Page of 1

0 of 0 people found the following review helpful:

November 20, 2023 Reviewer: Mike Eustace from Henderson, NV United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

Save money and profile yourself! October 27, 2023 Reviewer: Daniel Slusser from Berwick, PA United States   I almost bought this off different place because they had dissesdant arms profiled version for extra 50 bucks. I watched a YT video and ten minutes with my bench grinder then a Dremel and my action is buttery smooth! Was this review helpful to you?

0 of 0 people found the following review helpful:

Perfect August 3, 2023 Reviewer: Guy Peterson from Chattanooga TN United States   Fits perfectly into my Saiga 223 I converted. I did have to use one of the roll pins to make the safety work properly. Super light and smooth trigger pull now. Perfect trigger for any AK style rifle.  Thanks Was this review helpful to you?

0 of 0 people found the following review helpful:

Almost excellent. April 23, 2022 Reviewer: Justin Schupp from Carnegie, PA United States   The only thing this is missing is a trigger stop so essentially the trigger can just pull nearly all the way to the end of the trigger guard at least it's that way with the vepr 12 and I'm sure it'll be the same with the AK-47. What you can do is sand down the disconnector flat on the right side and sand the factory trigger stop so it fits in between the new trigger. Was this review helpful to you?

0 of 0 people found the following review helpful:

Feels great! December 24, 2021 Reviewer: Corey S. from Virginia   The install on the Saiga platform was mostly painless! The only work required was filing the bottom left corner of the safety to clear the disconnect so the safety would actually engage. Very much appreciated that the front tang was ground to fit! Install took less than an hour all said and done with function checks. Was this review helpful to you?

1 of 1 people found the following review helpful:

Good but be prepared for fitting October 4, 2021 Reviewer: Tom from USA   I placed this trigger group in a Lynx 12. 1. This trigger group does not use the factory tube bushing to hold the trigger, sear, and spring together for easy placement inside the receiver. I had to loosely set those pieces in the receiver and try to work the trigger pin through while pressing down on the sear. This was frustrating until I used this install tip. Push trigger pin in till it stops at the sear. Use hammer pin from the other side to align the trigger and bolt hold open/spring. Once lined up I could push down on the sear without it coming out of place. Once through the sear I could press the trigger pin through completely using the other pin as a guide. 2. The bolt carrier hit the top of the trigger hook if trigger was not held to rear during cycling.  This issue locked up the gun. I had to file the top right corner away from the (much thicker) trigger hook. Once rounded and smoothed out the shotgun cycles fine. Was this review helpful to you?

0 of 1 people found the following review helpful:

September 25, 2021 Reviewer: Viper 308 from Lyons, NY United States   Love these single stage triggers!!! I have them in 3- AK ‘s now and for the money you can’t beat um way cheaper than my AR triggers !!! Buy it and you won’t regret it! Was this review helpful to you?

0 of 1 people found the following review helpful:

June 23, 2021 Reviewer: Manuel Pagdanganan from Daytona Beach, FL United States   Great product .highly recommended Was this review helpful to you?