Home > SAIGA 223 >

CSS RIFLE SCOUT SIGHT RAIL MOUNT FOR ALL RIFLES

AK47 Saiga Vepr scout scope rail red dot CSS


 
Alternative Views:


Price: $39.95

Stock Status:
IN STOCK AVAILABLE FOR PURCHASE


SKU#: CSS-RIFLE-SCOUT
Qty:

Description
 
Sight Rail Mount allows you to mount any picatinny based Red Dot to all AK47's, Saiga Rifles and all standard Vepr rifles and Vepr 12 Shotguns.
Does not work with the integrated rear sight Vepr's version 2.

Replaces your factory standard AK47 rear sight.
Locks in place secure to hold zero.
Design allows your top cover to be removed for cleaning without removal of the mount.
Rail has 8 slots and is 3 5/16" long with a Milspec hard coat anodizing.
Made in the USA.
Installs easily in minutes and does not permanently alter the firearm.
Places your Red Dot scope at a perfect location for the fastest target acquisition.

Red Dot Scope in the picture is not included.
Works great with all the UTG red dot scopes sold separately.

Instructions to remove the rear leaf spring and iron sight:

a. securely hold the weapon in a rifle vice or bench vise (be careful not to crush or bend the receiver when clamping it in a vice).

b. raise the rear leaf sight to the highest elevation setting (normally 800-1000 but this varies weapon to weapon)

c. place the end of a flat bladed screw driver (or other similar tool) into the central groove near the hinge point of the sight leaf. A gentle tap on the screw driver with a rubber mallet is enough force to pop it free. During the mallet strike, the objective is to compress the leaf spring and force the axis pin out of the guide slot underneath. Wrap the leaf sight with a rag to prevent a forceful ejection and possible injury.

d. remove the leaf sight spring first and then rear iron sight. Store them together, you will not need the leaf spring unless you reinstall the iron sight.

Installation of Scout Rail

a. remove the screw from the side of the rail piece and place the rail piece in place

b. ttightent he side screws until they are hand tight, no need to torque them or locltite them.

c. tighten the front screws (the ones facing down) until the rail is secure. The front screws will apply tension to hold the rail in place. It is not necessary to torque them or locktite them.


Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 1 Write a review »

  0 of 1 people found the following review helpful:
 
5 of 5 Sight rail June 24, 2022
Reviewer: mike c from Yucaipa  
Used for my Mac 90. Sight spring was hard to get off. Rail itself was easy to install. Seems solid. Have not used it on range yet.

Was this review helpful to you?