Home > ALL PRODUCTS >

CAROLINA SAIGA 410 SHOTGUN TACTICAL BILLET QUAD-RAIL

CSS Carolina Saiga 410 Quad Rail Tactical


 
Price: $179.95

Stock Status:
OUT OF STOCK


SKU#: CSS-410-QUAD-2PC.SET
Qty:

Description
 
Saiga 410 Shotgun Aluminum Quad-Rail replaces the factory forearm.
Installs easily with the top rail section securing directly to the bottom forearm section.
Milled from solid billet for extra strength and Black Hard Coat Anodized for the most durable finish available.
Vented design allows for faster heat disbursement to help keep you barrel cool.
Made in the USA and counts for 1 922r compliant part.


This does not fit the Arsenal Saiga 410's that have a 2 piece hand guard.

410 Quad-rail Installation Instructions
1.Make sure the firearm is unloaded.
2. Remove the screw from factory forearm and pull the forearm off by sliding it down the barrel.
3. A 3/16” hole must be drilled in the bottom of the receiver .25” from the edge to secure the rear tab as an optional second secure point.
(You can also lay the tab on the receiver to act as a guide to mark the screw hole location)
4. Slide the forearm down the barrel and into position where the back tab is seated.
5. Place the supplied screw through the new forearm and then place 1 or 2 of the leveling spacers on the screw and then tighten the screw into the gas block.
(Some 410’s may need 1 or 2 to level the forearm correctly)
6. Now secure the back tab with the shorter supplied screw.
(Blue or Red thread locker is recommended for all screws)